75 CJ5 Transmission Crossmember
billyocup
Senior Jeeper
- Posts
- 662
- Thanks
- 6
- Location
- Arnold, CA
- Vehicle(s)
- 75 CJ5 304V8 T15 D20 D44 D30 2 1/2" lift, 05 Victory Kingpin, 2011 GMC Sierra 3500 Diesel 4x4
Does anyone have a picture or 2 of what the stock tranny crossmember on a 75 with a T-15 looks like?
I just dropped the engine and Transmission back in the frame and I'm having a heck of a time getting any of the holes on the crossmember and frame to line up. I have a sneaking suspicion that a PO substituted another crossmember. I also noticed, when I took it out, that the output yoke on the Transfer Case didn't line up with the rear diff. It was about an inch and a half farther to the left.
I've checked through all my manuals and a bit online, but I can't find a good enough picture so I can figure out how everything is supposed to fit together.
As always, thanks for the help.
Bill
I just dropped the engine and Transmission back in the frame and I'm having a heck of a time getting any of the holes on the crossmember and frame to line up. I have a sneaking suspicion that a PO substituted another crossmember. I also noticed, when I took it out, that the output yoke on the Transfer Case didn't line up with the rear diff. It was about an inch and a half farther to the left.
I've checked through all my manuals and a bit online, but I can't find a good enough picture so I can figure out how everything is supposed to fit together.
As always, thanks for the help.
Bill