• Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.

Adapting carb throttle cable to tbi

Adapting carb throttle cable to tbi
jgjeeper

jgjeeper

Jeeper
Posts
26
Thanks
0
Location
Milwaukee, Wi.
Vehicle(s)
1980 CJ7 , AMC 360 with a TBI, T-176, Dana 300, full float Dana 44 rear with spool,1983 Dana 30 wide trac with lock right, 4.88 gears and alloy shafts all around.
So I'm swapping a GM TBI onto my AMC 360. The carb had a stud with a ball end & socket end on the cable. The TBI has a straight stud with a groove for a clip. Is there anyway to adapt one to the other? Do I have to buy a whole new cable?
 
Mine was on a AMC 258 i6 / 4.2l , but I had to make an adapter plate and buy the ball studs, suppose you could go the other way and change the cable to match the TBI.

spaceball.gif
spaceball.gif
hly-202_7095_zpsa7e48f87.webp

IMG_0508_zpscaa4dfae.webp
 
You must log in or register to reply here.

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$60.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  30.0%
Contribute
Back
Top Bottom