BEST in tank fuel pump and sender for GM TBI on cj7 jeep!
76cj7chick
Old Time Jeeper
- Posts
- 1,235
- Solutions
- 1
- Thanks
- 8
- Location
- WA
- Vehicle(s)
- 1976 CJ7 Jeep with a engine/tranny/wiring harness out of a 1988 s10 blazer 4.3l v6 with th700r4 automatic tranny and a cj7 Dana 300 transfer case with Novak adapter.
Complete wiring harness from the s10 blazer. Painted with HOT PINK Pearl paint with standard sized metallic halographic pink flakes. Painted by me -a newb. New rear, front and side three wire LED lights, New parts, new custom dash-by me And a lot of guidance from fellow jeepers and lots of prayers etc.... :p
Howdy all!
I've upgraded my carb to a GM TBI system... And would prefer the in tank pump assembly...
I've heard Novak makes one... But am kindof strapped for cash... I am willing to pay up to $140 ish for the assembly or convert my current fuel sending unit to a fuel pump assembly?
Although I have a 76 CJ7 ---I installed a plastic 78-86 CJ7 jeep tank from MTS 15gal part # 0051...
Would it be easy and wise to convert my current sending unit to an electric fuel pump assembly? If yes, anyone have pictures of this process?
---I'm thinking of using a fuel pump rated for 12-15psi, like E3902... But not certain if it will work properly as I don't have a bracket to hold it in place...
Just concerned about wiring... Do I need to drill a hole in the top or can I connect the pump power to the sender connector... Then there is the ground wire for the pump..
IF ANYONE HAS BEEN SUCCESSFUL IN THIS MOD PLEAAAAAAAAASE UPLOAD PICS AND INSTRUCTIONS!:drool:
OR
Get the Sender unit from Novak and install a lower psi fuel pump in it?
OR
Some people say that the sender for a yj 2.5l tank will work in CJ7 ... BUT I contacted MTS and they said that their YJSU-1P unit measures 9.5" long and top plate is the standard 3.5"
My CJ7 fuel tank has a 2" opening/hole...
PLEASE HELP! NEED TO DRIVE MY HEEP!!!!


I've upgraded my carb to a GM TBI system... And would prefer the in tank pump assembly...
I've heard Novak makes one... But am kindof strapped for cash... I am willing to pay up to $140 ish for the assembly or convert my current fuel sending unit to a fuel pump assembly?
Although I have a 76 CJ7 ---I installed a plastic 78-86 CJ7 jeep tank from MTS 15gal part # 0051...
Would it be easy and wise to convert my current sending unit to an electric fuel pump assembly? If yes, anyone have pictures of this process?

Just concerned about wiring... Do I need to drill a hole in the top or can I connect the pump power to the sender connector... Then there is the ground wire for the pump..
IF ANYONE HAS BEEN SUCCESSFUL IN THIS MOD PLEAAAAAAAAASE UPLOAD PICS AND INSTRUCTIONS!:drool:
OR
Get the Sender unit from Novak and install a lower psi fuel pump in it?
OR
Some people say that the sender for a yj 2.5l tank will work in CJ7 ... BUT I contacted MTS and they said that their YJSU-1P unit measures 9.5" long and top plate is the standard 3.5"
My CJ7 fuel tank has a 2" opening/hole...
PLEASE HELP! NEED TO DRIVE MY HEEP!!!!


