CJ Turn Signal
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
CJ Turn Signal
- Thread starter mycj7
- Start date Start date:
- Last post Last post:
hole
Crazy Sr. Respected Jeeper
- Posts
- 3,567
- Media
- 28
- Thanks
- 32
- Location
- St George Utah
- Vehicle(s)
- 83 CJ 8, 258 I6, T19, 4-1 Dana 300,4.0 Head, Mopar MPI, 10k winch, OME YJ springs w/3" lift,CS 144 Alt upgrade,Locked 20 & 30, Border Collie co-pilots are stock.
Had a similar issue years ago, new one from Napa solved it 
Torxhead
Always Off-Roading Jeeper
Its great to hear you can still get parts like that from over the counter. I would think that part would also apply to more modern applications though. I once had an issue with my turn signals that was resolved by blowing out the dirt that had collected through that turn signal actuator clearence hole.
hole
Crazy Sr. Respected Jeeper
- Posts
- 3,567
- Media
- 28
- Thanks
- 32
- Location
- St George Utah
- Vehicle(s)
- 83 CJ 8, 258 I6, T19, 4-1 Dana 300,4.0 Head, Mopar MPI, 10k winch, OME YJ springs w/3" lift,CS 144 Alt upgrade,Locked 20 & 30, Border Collie co-pilots are stock.
Torx, I was surprised they had it in stock myself, but as you say it probably fits another vehicle too
cerrajero
Senior Jeeper
the column is basically a GM column.
and Yes on Napa as well as Oreilly......and I like the term "turn signal actuator clearence hole".
and Yes on Napa as well as Oreilly......and I like the term "turn signal actuator clearence hole".
GatorBate
Senior Jeeper
I just replaced mine with one from Carquest. looked like it had been on the shelf since the 80's. The plug was a little different but it was easy to switch the wires out with the old plug. Mine was doing the something as yours. I found that if I signaled right and pushed down on the turn signal lever (like high, low beam on modern cars) then it would work.
Last edited: