Clutch linkage
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Clutch linkage
- Thread starter weithman5
- Start date Start date:
- Last post Last post:
- Posts
- 2,167
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 626
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
ill do my best as i dont have a pic.
the ball sits on top of the pedestal usually a lil grease will help hold it in place while u get the fork on.
the fork clips into the back of the throw out bearing then pivots on the ball. this is all inside the bell housing.
outside the bell housing its pretty straight forward your clutch pedal is attached to the "Z" bar (the bar connected to the side of the block and top of the frame) this i can get a pic of.
from the "Z" bar is another rod that sits in the little indentation on the shift fork.
finally the spring connects to a little hole about in the middle of the fork and attaches to the bell housing for return action.
i will post pics in a few minutes
Sry for the crappy pic's
the ball sits on top of the pedestal usually a lil grease will help hold it in place while u get the fork on.
the fork clips into the back of the throw out bearing then pivots on the ball. this is all inside the bell housing.
outside the bell housing its pretty straight forward your clutch pedal is attached to the "Z" bar (the bar connected to the side of the block and top of the frame) this i can get a pic of.
from the "Z" bar is another rod that sits in the little indentation on the shift fork.
finally the spring connects to a little hole about in the middle of the fork and attaches to the bell housing for return action.
i will post pics in a few minutes
Sry for the crappy pic's
Last edited:
- Posts
- 2,167
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 626
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
Sounds right
Sent from my E6810 using Tapatalk
Sent from my E6810 using Tapatalk
