Custom AMC20 Full Floater
hole
Crazy Sr. Respected Jeeper
- Posts
- 3,567
- Media
- 28
- Thanks
- 32
- Location
- St George Utah
- Vehicle(s)
- 83 CJ 8, 258 I6, T19, 4-1 Dana 300,4.0 Head, Mopar MPI, 10k winch, OME YJ springs w/3" lift,CS 144 Alt upgrade,Locked 20 & 30, Border Collie co-pilots are stock.
I'm asking this for a friend who has an 83 CJ7 with bent tubes on his AMC20 and would like to get the groups thoughts. He tried joining the board weeks back to ask this himself, but a snafu locked him out and he cannot log on until it gets resolved. His question:
" I am looking to use front spindles for making a rear full floater. Has anyone heard of this? I would have to make flanges and tube for center housing"
He is a fabricator by trade and the only outside help he would need is someone to make the axles. He put a Dana 44 up front last year so he has the Dana 30 laying out back to harvest the spindles off of.
" I am looking to use front spindles for making a rear full floater. Has anyone heard of this? I would have to make flanges and tube for center housing"
He is a fabricator by trade and the only outside help he would need is someone to make the axles. He put a Dana 44 up front last year so he has the Dana 30 laying out back to harvest the spindles off of.