TCase Dana 300 intermediate gear
JohnKcj5
Jeeper
I'm rebuilding my Transfer Case . The inside of the intermediate gear has imprints from the roller bearings. Where can a get a new one. I'm only finding the gear for a Dana 18 and 20.
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
TCase Dana 300 intermediate gear
- Thread starter JohnKcj5
- Start date Start date:
- Last post Last post:
Transfer case
WHATROAD
Senior Jeeper
- Posts
- 757
- Media
- 18
- Thanks
- 103
- Location
- Colorado Springs
- Vehicle(s)
- 1984 cj7 RENEGADE, Hard Top, factory air, reman 304 v8, ax15, D 300, D 30, AMC 20 with one piece axle, welded tubes and a searchers truss system, 4.56 gears, 4" lift, BFG 33x12.5x15, DirtWorx front and rear bumpers, rock sliders
Not sure what they have for sale anymore but you could check in with Novak conversions
CJ
Admin
- Posts
- 22,875
- Featured
- 5
- Media
- 897
- Resources
- 193
- Solutions
- 45
- Thanks
- 790
- Location
- Central FL
- Vehicle(s)
- '72 CJ5, 401, T18, D20, D44, D30
'82 CJ8, 258, D300, AMC20, D30
I agree, I bet Novak has one. To keep this from happening again it should be put in 4 wheel drive from time to time so the gear rotates and the bearings do not mark the gear.
Novak does not specifically list the gear but most of the time they have individual gears if you call.
www.novak-adapt.com
Novak does not specifically list the gear but most of the time they have individual gears if you call.
Parts for the Dana Model 300 Transfer Case
Rebuild, repair and upgrade components for the Dana 300 transfer case