Body Let me hear the bad news

[bennylava]

I can already hear it... "Get a new body".

This thread is to help me answer the question "How much will it cost if I don't get a new body"?

This CJ7 belongs to my wife, and it holds sentimental value to her. Her dad used to take her off-roading in it back in the late 1980s when she was a kid. So getting a new body would sort of defeat the purpose. If it were mine, I would probably just buy a whole different jeep and put this thing on craigslist.

But instead, it's up to me to fix it up. So I'm hoping you guys would be able to tell me how much money I'm looking at, to get a good paint job on this thing, with all bodywork finished out. $10,000 right? LOL

 

[bennylava]

Well I don't think we'll have to replace any of the body, as it's a southern vehicle. There's no rust other than surface rust. At least none that I've been able to find. All seems pretty solid.

If we have to get a new frame then oh well. I may consider that aftermarket frame, if it doesn't make the ride too stiff.

 

[Belizean]

How is the area of the body where the windshield hinges bolt to the body ? That area on the inside can get rotten with rust. On the front side and also the side area from my thumb to the top of my finger. I’m talking about the inside because it rusts from the inside out.

 

[bennylava]

Thanks for the help! I'll be sure to look those spots over really well from the inside. Anywhere else prone to rusting? I'll check the frame with a scope too.

 

[Belizean]

Just below that area, below the Jeep lettering on the inside where there is a brace, between the body and that brace, I think it’s called the A piller. Also under the roll bar where it bolts to the body.

 

[jzak]

How is the area of the body where the windshield hinges bolt to the body ? That area on the inside can get rotten with rust. On the front side and also the side area from my thumb to the top of my finger. I’m talking about the inside because it rusts from the inside out.

Yup! I've gone through two windshield frames and hinges on two separate CJ5 's. That whole area just rots from the inside out.

 

[bennylava]

Well if it is, maybe somewhere sells replacements I can weld in. Hopefully not.

 

[CJ]

Well if it is, maybe somewhere sells replacements I can weld in. Hopefully not.

The best USA made replacement body parts that fit and are the same as original gauge. Not other junk.

Classic Jeep Body Parts - Made in USA | Classic Enterprises

Jeep and WILLYS replacement body parts and panels, Made in the USA from original gauge steel or heavier. From CJ to TJ; Jeepster, Wagons and Trucks. We manufacture Floor Panels, Side Panels, Floor and Body Supports and more!

www.classicent.com