Rear Corners

[007]

I bought a YJ tub and want to replace the corners with CJ corners for fuel, etc. Does anyone sell these with the holes / cutouts already done?

 

[Petescj]

Yup. Thats what Im doing with mine. Heres one example

Warrior Products 904APC - Warrior Products Rear Corners with Holes for 76-86 Jeep® CJ7 - Quadratec

 

[007]

I'm just looking for the replacement panel with holes etc. not a cover.

 

[Petescj]

My fault

Original Replacement Parts J5764220 - Passenger Side Rear Steel Replacement Body Corner for 76-86 Jeep® CJ-7 - Quadratec

Original Replacement Parts J5764221 - Drivers Side Rear Steel Replacement Body Corner for 76-86 Jeep® CJ-7 - Quadratec

 

[Sasquach]

Don't be so hard on yourself Pete.
Classic Enterprises - Restoration, Reproduction Parts for Studebaker, Jeep & Ford

 

[Petescj]

That was the first place I went. Didnt see them.

Don't be so hard on yourself Pete.
Classic Enterprises - Restoration, Reproduction Parts for Studebaker, Jeep & Ford

 

[Sasquach]

Well I did not look I just threw it out there assuming they did. My Bad

 

[mtnwhlr]

Instead of replacing both corners don't you think it would easier to just cut a hole on the right side and weld up the hole on the left side?

 

[Jimbos76cj]

I picked up a Cj before that had a YJ tub on it and they just cut the hole on the passenger side and used a tag holder I thing from a TJ. Ic covered the YJ hole perfectly.

 

[007]

Thank you folks... I could do the hole myself, but the tub I bought needs corners anyway so I just figured I'd try to get them as close to ready as possible.

I appreciate it!