Rollbar Swap
007
Crazy Sr. Respected Jeeper
- Posts
- 3,451
- Media
- 5
- Solutions
- 1
- Thanks
- 64
- Location
- Reno, NV
- Vehicle(s)
- 1977 CJ-7 Renegade (Daisy Jane), Levis trim, 304, TH400, BW1339 (MM), D30/Auburn Max, AMC20/Detroit/G2's, 4.88's, 33" BFG MT KM2's, Edelbrock Performer intake, Holley Sniper 4bbl EFI, MSD6, MSD ProBillet distributor, OME shocks, 4" ProComp lift.
My Jeep is a 77 and has the older rollbar that is perpendicular to the ground (and I hate it) and I want to swap with my late eighties / early nineties YJ rollbar that's swept back like the late 79's-86's and mounts the same.
I know this is not a direct swap out, and will require some welding and bolt hole filling, but is there any real issue with doing this? Will I be able to make it fit down behind the front seats on the floor there easily enough? I don't need it perfect, just reasonably sturdy.
I know this is not a direct swap out, and will require some welding and bolt hole filling, but is there any real issue with doing this? Will I be able to make it fit down behind the front seats on the floor there easily enough? I don't need it perfect, just reasonably sturdy.