Brakes Rotor Wheel bearing Hub assembly?

[Starbrick Jim]

I am working on front axle of CJ7 1983 Renegade . I see that the front rotors are part of the wheel bearings/hub assembly. I want to replace the badly rusted rotor but it all looks like one unit. For replacement parts, I am not finding the rotor/hub/bearing assembly available as a unit. Did Jeep make a change or an update to this system? I find no ability to separate the rotor from the existing hub, see attached pictures. I am asking for thoughts and directions as I am on pass front and will also repeat the process for driver front. Thanks.

 

[TSB8C]

My '84 is not a single assembly. The rotor is a separate part from the hub and the bearings. I have the Dana 30 in front. They were quite stuck (not as rusty as yours looks) and required some effort to separate them.

 

[Starbrick Jim]

Thanks for the reply. My front is an AMC20 so hopefully it should not matter or make a difference. Should it? I like your solution better than trying to find the assembly that looks like mine.

 

[Serdich77CJ5]

Jim I'm in the process of doing the same to my 77 CJ5 . The assembly is two pieces you just have to pound out the studs and they will separate.

 

[Starbrick Jim]

Thank you very much for the direction. Well, you were correct, I did punch out the studs and it came apart. I could have sworn it was one piece as the rust hid it well. Moving on in my new frame up rebuild.