YJ half doors and a roll cage
cjbilly
Jeeper
- Posts
- 51
- Thanks
- 0
- Location
- East Central Indiana
- Vehicle(s)
- 1984 CJ 7 with rebuilt AMC 360/ 2 bbl. with Turbo 400 and Dana 20 transfer case (twin sticked). Dual red-top Optima's. Lokar shifter with rebuilt/modified tranny. Dual Flowmasters out the back.
1985 Dana 30 and 1986 CJ Dana 44 with 3.73's. Steering box brace. Central axle, tranny and transfer case breather box. Detroit locker (rear) and ARB (front). 35x 12.50-15 MT/R's on 15 x10 ION alum. simulated beadlocks.
Prior to getting my front cage and half doors painted, it came to my attention that the doors will not latch due to the interior plastic/Sahari door panels touching the cage. Oh well, I'll deal with this later. 
Other then heating up the plastic door panels to "mould" them around the cage, I thought about buying a pair of brushed aluminum factory door panel inserts.
Warrior Products - Jeep - Factory Replacement Door Handles | Warrior Products
Has anyone bought these inserts or have these installed on their CJ's? What do you think of the cost and workmanship?
As anyone come across this problem? If so, how did you resolve it.
In the meantime, I have a set of vinyl halfdoors I can use.
Other then heating up the plastic door panels to "mould" them around the cage, I thought about buying a pair of brushed aluminum factory door panel inserts.
Warrior Products - Jeep - Factory Replacement Door Handles | Warrior Products
Has anyone bought these inserts or have these installed on their CJ's? What do you think of the cost and workmanship?
As anyone come across this problem? If so, how did you resolve it.
In the meantime, I have a set of vinyl halfdoors I can use.
