1978 CJ5 (304-360-401) distributor cap
Turbogus
Old Time Jeeper
- Posts
- 1,319
- Featured
- 1
- Thanks
- 27
- Location
- Albany, OR
- Vehicle(s)
- '78 CJ 5 Renegade (Black Betty) Motor AMC 360, T150 trans, 20 tc, Dana 30 front and Dana 44 rear w/posi
'96 GMC K1500 Suburban (Big Blue Basterd) fully loaded with over $10k in options
Hi gang, I'm finalizing the cylinder head repairs and comig down to the wire, I noticed the distributor cap's relief for the distributor wiring is about 10* off from it's entry into the distributor, allowing crud to get into the distributor. The ignition is Ford EEC-1 from the looks of it. I swapped out the Standard for an Echlin at NAPA and it is the same, what's going on with this?
Last edited:
