Misc AMC 20 One piece shaft bearings

[Tim_Coble]

So, I'm an idiot - I watched the videos, read the forums and still screwed up. One of my backing plates was put on inside out.

I managed to cut off the press ring and bearing without too much drama after kicking myself for several minutes when I realized what I had done. But now, my question is what bearing set to get. Are the bearings and press ring the same as the two-piece original?

Amazon has this set: "Yukon Gear & Axle (AK M20-1PIECE) Axle Bearing & Seal Kit for AMC Model 20 Rear Differential". Yukon's website doesn't specifically say the kit is for a one piece. They sell the one-piece kits but none of the bearing kits call out the axle type.

Thanks in advance.