axle swap
carljones
Jeeper
- Posts
- 2
- Thanks
- 0
- Location
- waverly, TN
- Vehicle(s)
- 1976 CJ5 with dana 30 front end and dana 20 rear end. 3 speed manual. 304 engine
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
axle swap
- Thread starter carljones
- Start date Start date:
- Last post Last post:
Old Dog
Always Off-Roading Jeeper
- Posts
- 13,880
- Media
- 82
- Thanks
- 5
- Location
- Stonelick Lake, Ohio
- Vehicle(s)
- 83 CJ7 350 tbi, TH350, D300 twin sticked & clocked, narrowed Chief D44 Eaton Elocker & Moser shafts, Explorer 8.8 Detroit locker, 410's, RE 4.5" spring lift 1" body lift, 35" Claws, cage tied to frame, Corbeau baja seats, HD tie rod and draglink, u-bolts flipped, custom skid plate and sliders, Warn 9.5ti winch with Amsteel synthetic line
yes there should be a spacer on each side, they set the bearing preload. (sometimes they need to be shortened)
If you need bearings, you also need to get them from the axle manufacturer as the bearing retainer is different than what the parts stores have.
I know Superior axle sells them and I imagine Moser does also.
If you need bearings, you also need to get them from the axle manufacturer as the bearing retainer is different than what the parts stores have.
I know Superior axle sells them and I imagine Moser does also.
Last edited: