Bell crank clutch release backwards

[1984 CJ7]

I just installed a new one from Morris 4x4 and realized I installed it backwards. It seems to be the same though so will it really matter? I have the grease niple towards the outside but in the illistrations, it is on the inside near the Transmission . I just hate to have to redo it unless it matters.

Any thoughts?

 

[BusaDave9]

Can you post a picture?
When you press the clutch it should push down on the linkage. That should cause the shift fork to press. Is it still working like that?

 

[IOPort51]

How do you decide it's backwards?

 

[1984 CJ7]

It works fine but the grease nipple it on the other side. So, it is installed reverse compared to the diagram. It still shifts smoothly though.

 

[BusaDave9]

So the tab that should be for the clutch fork linkage is connected to the pedal linkage and vice versa.
I think the size of those tabs is the same. I don't think it makes much difference except for the grease fitting. Can you still get a grease gun in there?

 

[1984 CJ7]

Yeah, that is it. It actually makes more sense to install it like I have. It's is easier to get to the gease nipple.