Bezel for single gauge?
busterswt
Jeeper
PO installed a tach in the dash and really botched the hole. I'm looking to cover up the damage with some sort of bezel extending about 1" from the sides. Does anyone make something like that?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Bezel for single gauge?
- Thread starter busterswt
- Start date Start date:
- Last post Last post:
thiswontbetooexpensive
Full Time Jeeper
- Posts
- 2,197
- Media
- 74
- Thanks
- 2
- Location
- Madison County, TX
- Vehicle(s)
- 1980 CJ5, Stock and original
258I6, Dana 300, T 176
(poor thing needs a little bit of time and a few kind words)
Find you a metal fab place and have them make you one that is the factory size ID and have studs welded to the back. They you either paint it, have it chromed, or powder coat it. Cost would be cheaper than a new dash blank IMO. Good luck!