gasket between dana 300 and tranny

[superchicken]

Is there a gasket that goes between the Transfer Case and the Transmission on an 84 CJ with a TF999 and Dana 300 ?

 

[BrockGrimes]

It's been awhile but, If I'm not mistaken it should be this one:
http://www.tellico4x4.com/product_info.php/cPath/2880_87_522/products_id/6056
Amazon.com: Omix-Ada 18603.03 Dana 300 Transfer Case Gaskets & Oil Seals Kit: Automotive

Someone who's been in one recently can confirm.

 

[superchicken]

Ok guys no gasket between the tranny and Transfer Case . The rear seal on the Transmission was leaking. here is where the seal was.

Here is the shiny new seal in place where it belongs

Now its happy again

 

[Cheepjeep85]

that is a good lookin CJ8 . never seen a top like that before though, guess its an australlian thing

 

[Petescj]

They were sold overseas and called the Worldcab. There is some info on them around the site. There was a CJ7 version as well.

that is a good lookin cj8. never seen a top like that before though, guess its an australlian thing

 

[gert]

seems stange to not have a gasket You have a rustable cast iron Transfer Case mounted to an aluminum Transmission .... in the aircraft bussiness that usually causes a problem

 

[IOPort51]

seems stange to not have a gasket You have a rustable cast iron transfercase mounted to an aluminum trans.... in the aircraft bussiness that usually causes a problem

I am a big fan of Locktite 515. on that joint even if there is nothing to get out there would be a lot of stuff trying to get in. Gert has a point, I never thought of the need for a dielectric material. pondering that could make your head hurt.

 

[gert]

well just dont ever trap water in there at least it will be years before it becomes a big problems