HEI Education needed please
thiswontbetooexpensive
Full Time Jeeper
- Posts
- 2,197
- Media
- 74
- Thanks
- 2
- Location
- Madison County, TX
- Vehicle(s)
- 1980 CJ5, Stock and original
258I6, Dana 300, T 176
(poor thing needs a little bit of time and a few kind words)
I am going back together at long last. Just ordered up some stuff to get it finished up...almost.
I have been reading and reading about the HEI deal/upgrade and am more confused now than I was a few days ago! IF I get an HEI distributor, what all else can I NOT worry about replacing. (What I had was functional; I drove it into the garage to take the battery off in November.) As far as I can tell, to go back with stock, I need to procure a new distributor complete with rotor and cap, the coil thing bolted to the side of the engine, and ignition module that is bolted to the driver fender in addition new plugs and wires of course.
Again, IF I get an HEI distributor, what else needs to be replaced in the aforementioned list? As always, any and all help is appreciated.
I have been reading and reading about the HEI deal/upgrade and am more confused now than I was a few days ago! IF I get an HEI distributor, what all else can I NOT worry about replacing. (What I had was functional; I drove it into the garage to take the battery off in November.) As far as I can tell, to go back with stock, I need to procure a new distributor complete with rotor and cap, the coil thing bolted to the side of the engine, and ignition module that is bolted to the driver fender in addition new plugs and wires of course.
Again, IF I get an HEI distributor, what else needs to be replaced in the aforementioned list? As always, any and all help is appreciated.
