Leak from rear of 258 (not RMS or valve cover)
DaveMueller
Active Jeeper
- Posts
- 271
- Media
- 1
- Thanks
- 5
- Location
- Ohiopyle, PA
- Vehicle(s)
- '76 CJ5 with an '88 258 from a YJ.
AMC20, D30, D20, T150.
I just replaced my RMS along with the one piece oil pan gasket. I'm getting a large puddle dripping from the skid plate on the oil pan. It's running down the back of the pan in front of the inspection plate. I just finished rebuilding the T-150 , the bottom of the bell housing is clean. The top of the block is clean so it's not the valve cover (new also).
PCV is new and plumbed properly.
So what else could be leaking from the back? Any other causes for the rear main to leak other than a bad seal?
PCV is new and plumbed properly.
So what else could be leaking from the back? Any other causes for the rear main to leak other than a bad seal?