Pinion gear crush spacer
simple man
Jeeper
I am replacing the rear pinion oil seal and have a question about setting the pinion preload.
When I attempted to measure the preload at the pinion nut the pinion rotates so easily that there is no torque reading.
Any suggestions on how to proceed when torquing the new pinion nut.
I am concerned that the lack of a torque reading may indicate other problems.
Thanks
Sent from my A1-830 using Tapatalk
When I attempted to measure the preload at the pinion nut the pinion rotates so easily that there is no torque reading.
Any suggestions on how to proceed when torquing the new pinion nut.
I am concerned that the lack of a torque reading may indicate other problems.
Thanks
Sent from my A1-830 using Tapatalk