Pulling 360

[Germy]

Thanks cj, that is not what I was thinking! I'll be sure to get one

 

[007]

Done!!!! Thanks all! Now I guess I'll pressure was and scrub. The new bultear pulleys look as though they will be nice. I am having heads done, eddy performer hot dipped and the timing cover dipped. Looks as though I may get this done on he cheap? If I was going tfor a cam, what is the best choice without changing springs. I just want the lope

I don't know if this got answered or not but I would use the Edlebrock performer cam. It's great for low-end torque and daily driving.

 

[Germy]

Cool, thanks. I want a cam with low end, but wouldn't mind a lope

 

[Germy]

Ordering parts, what are the benefits/disadvantages of solid motor mounts?

 

[mtnwhlr]

Trust me you do not want solid motor mounts I have gone that route and after a month went back to rubber.

 

[Germy]

Ok thanks! I'm just seeing solid aluminum, the two piece factory and the energies poly. For 20 I can have both stock replacements.

 

[Germy]

Any suggestions on mounts? Factory or poly?

 

[mtnwhlr]

I would go factory.

 

[Germy]

Cool thanks. Little cheaper too!

 

[mylittlecj5]

I tore up 2 sets of rubber mounts, then I went to poly. I doubt I will ever go back.
Granted mine is not a very street friendly, well mannered truck, so any extra vibes the poly transmits I don't notice anyways.