rubber block or not ?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
rubber block or not ?
- Thread starter steve o
- Start date Start date:
- Last post Last post:
Cheepjeep85
Crazy Sr. Respected Jeeper
- Posts
- 4,934
- Media
- 57
- Thanks
- 0
- Location
- Chickamauga, Ga
- Vehicle(s)
- 1985 Jeep CJ7, 258, t-176, D300, AMC20, D30
There shouldn't be a block in between the axle and spring, with a spring under setup that lowers the jeep on one side. Now if it were a spring over that would lift it, but it shouldn't be rubber, it should be steel.
Droooiiddd 2
Droooiiddd 2
CJim7
Crazy Sr. Respected Jeeper
- Posts
- 3,590
- Media
- 1
- Thanks
- 4
- Location
- Twin Falls ID
- Vehicle(s)
- '84 CJ7 - 430hp 401 on propane - T18a/D300 twinsticked, Superior axles, Lockers, full boatsides, Warn 8274, OBA, 36" TSL's.
Looks like one side was sagging so they quick-fixed it by blocking the other side 
steve o
Jeeper
guess ill have to get it on some dead level ground and have a measure up, might be a new pair of rear springs