Stainless Steel Door Handles-rust removal
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Stainless Steel Door Handles-rust removal
- Thread starter iramiles
- Start date Start date:
- Last post Last post:
Shazam
Active Jeeper
- Posts
- 260
- Media
- 14
- Thanks
- 0
- Location
- North Carolina
- Vehicle(s)
- 1979 CJ-5 Renegade with '74 304 V8 & Edelbrock manifold & carb, Heddman headers & sidepipes, T-150 3 speed, Dana 20, Dana 30, AMC 20
Well, I'm assuming they're not stainless if they've rusted. But I've had good luck with a wire brush drill attachment and mineral oil. Good luck!
iramiles
Jeeper
Right....but they're the pseudo-stainless handles, not black. I'll give the brush and oil a go...thanks!
IOPort51
NOT the voice of reason Jeep-CJ.com
- Posts
- 13,956
- Featured
- 5
- Media
- 458
- Thanks
- 11
- Location
- Garland Texas
- Vehicle(s)
- 1977 cj-5
4.2 W/MC2100 carb, 4.0 head W/3 angle valves,SS Header,TFI ignition with MSB-6 offroad module,CS144 140 amp RPS alternator with remote regulator T-150,d-20,Dana 44 with OX lock and disk brakes. D-30 with Spartin locker,
skyjacker 2.5 lift?nitro shocks,31" BFG A/T off road.8000 lb Warn winch, original owner.=^)
2006 Toyota Tacoma
red or gray scotch bright pads.
BrockGrimes
Jeep-CJ.com Archive Master
Fine steel wool and oil, water, coke, some kinda liquid.
I like fine steel wool and soapy water.
Do a small test patch unless you plan on painting them.
Some methods will scratch/dull the surface.
I like fine steel wool and soapy water.
Do a small test patch unless you plan on painting them.
Some methods will scratch/dull the surface.