Whining transfer case.
MYJX
Jeeper
DANA Transfer Case whines in 2W high but not in 4 low or high. any advice?
Whining transfer case.
- Thread starter MYJX
- Start date Start date:
- Last post Last post:
BajaEdition
Resident 'Old' Jeep Shaman
- Posts
- 5,486
- Featured
- 1
- Media
- 136
- Resources
- 2
- Thanks
- 7
- Location
- Riverside Ca
- Vehicle(s)
- 67 cj5,225 Dauntless, D30,chrome molies, detroit, D44, full floating detroit, custom steering, disc all the way around,2 inch lift on 31s, armored up
70 cj6 4 inch lift
which Dana t case?
BajaEdition
Resident 'Old' Jeep Shaman
- Posts
- 5,486
- Featured
- 1
- Media
- 136
- Resources
- 2
- Thanks
- 7
- Location
- Riverside Ca
- Vehicle(s)
- 67 cj5,225 Dauntless, D30,chrome molies, detroit, D44, full floating detroit, custom steering, disc all the way around,2 inch lift on 31s, armored up
70 cj6 4 inch lift
Here is a link that has a diagram of what is turning in each of the 4 positions a Dana 20 can be shifted into
http://www.jeep-club.at/Umbauten/teraflex-umbau-pdfs/neu/low20_install.pdf
If you look into the 2wd high diagram, everything turning is dark, the problem should be in that shaft assembly as it disappears when shifted into 4wd.
I would just buy a general rebuild kit as long as I was redoing one assembly why not do them all.
http://www.jeep-club.at/Umbauten/teraflex-umbau-pdfs/neu/low20_install.pdf
If you look into the 2wd high diagram, everything turning is dark, the problem should be in that shaft assembly as it disappears when shifted into 4wd.
I would just buy a general rebuild kit as long as I was redoing one assembly why not do them all.
MYJX
Jeeper
everything that turns in 2 High also turns in 4 high and low. So if its going to whine should'nt it do it in all the gears?