700r TRANSMISSION SENSOR

[bearsden]

Help! After doing the nutter by-pass and removing the unused wiring I noticed two wires going back to the driver side of my Transmission to a sensor of some sort. Not being to familiar with the 700r trans. I'm not sure where to connect them. And in haste of things dont recall where they were connected before. Does anyone out there have that trans.that can help ? Other than that, things went great thanks to all the help from the forum!!!

 

[Torxhead]

You might find some help here:The GM TH700R4 & 4L60E Transmission - Novak Conversions

 

[Barry2]

The ones on mine are for the torque converter lockup. Look up a schematic on the web to see how to wire it up

 

[bearsden]

I did start doing some reading there last night,some of that info is over my head!! Thanks Torxhead !!!!!

 

[bearsden]

Thanks Barry2,I believe evreything is wired up ok in the Transmission so I'll do some digging for a schematic.I just don't know exactly what it does but it looks like just a hot wire and ground??? I don't even know if it was connected before i started pulling wires or if it was just bundled up with something. Previous owner had it installed and was suppose to send me a bunch of paperwork when I purchased the jeep a couple years ago but would never return my calls.So being 1/2 way new to the jeep thing i'm trying to figure out what all he's done.Really appreciate all tha help here !!!