Another MC2100 Question
Nalanthi
Jeeper
- Posts
- 24
- Thanks
- 0
- Location
- Albuquerque
- Vehicle(s)
- '84 CJ7 258/4.2L 6cyl, TF999, Dana 300, 3.31 (barf) AMC 20 w/ one-piece chromoly rear/Dana 30 front, Holley7448
Good morning, all.
Long story short I recently procured a '84 CJ7 - did an HEI swap and cleaned up a lot of the wiring. The previous owner was running (or attempting to run) a Holley 7448 which absolutely sucks, so after a bit of research I ordered a MC2100 w/ 1.08 venturis.
I see a few jet numbers getting tossed around, mainly 46-48 and was wondering if 45s would be a better starting point for an elevation of 6000ft?
Long story short I recently procured a '84 CJ7 - did an HEI swap and cleaned up a lot of the wiring. The previous owner was running (or attempting to run) a Holley 7448 which absolutely sucks, so after a bit of research I ordered a MC2100 w/ 1.08 venturis.
I see a few jet numbers getting tossed around, mainly 46-48 and was wondering if 45s would be a better starting point for an elevation of 6000ft?
