Reverse light wiring questions

[Flex BT]

What I've got: the wires going from the Transmission / Transfer Case to the molex connector / harness connector thingy:



Wires going from the reverse lights to an area by the parking brake:



The two light green wires by the parking brake are labeled "to brake lights" and to "brake lights power +B" or something like that. When the "to brake lights" gets 12v the brake lights come on.

My questions:

I'm assuming I need to get the two green wires through the firewall. How do I do that? Shouldn't they be connected to the back of the fuse box (or that relay?), with a harness coming out the other side to connect to the transmission side? I can't see anywhere on my engine side of the firewall that has any wires labeled for the backup / 4WD lights or any connectors that look anything like the plug coming off the tranny/xfer case.

edit: Please fix the email notifications for replies! I don't want to have to check this thing every few hours or forget about it being here.

 

[Torxhead]

Flex, are you looking to hook up the back up lights? Since that circut comes from the bu/seat belt fuse which is hot with the ignition switch in the on position. Actually any fused ignition on hot line would work.

 

[Flex BT]

Yes, I am trying to hook up the back up (reverse) lights and 4wd indicator.

I don't think there is such a fuse on my panel. Even if it was, shouldn't there be something that molex style connector / harness attaches to on the engine side of the firewall, or is that something the PO removed when installing the painless harness?

 

[jdcaples]

This manual might help

https://www.painlessperformance.com/Manuals/10150.pdf

-Jon

 

[Flex BT]

I have seen the painless manual. My PO removed the pigtail that goes between the Transmission and bulkhead (the one pictured) and I don't know where those wires need to run to on the bulkhead. I think the three wires on that pigtail all need to go to the bulkhead on Reverse signal, 4WD signal, and reverse signal power, right? I can't find those in the manual on the bulkhead except for the 4WD indicator. I'm also having a hard time finding out where the two wires in the other picture need to hook up on the interior.