Two Piece Front Driveshaft
aglinks
Active Jeeper
- Posts
- 317
- Resources
- 1
- Solutions
- 1
- Thanks
- 28
- Location
- Flagstaff, AZ
- Vehicle(s)
- ‘83 CJ7, 4.8L Vortec, TF999, D300, AMC20, D30
Hey all,
I have a TF727/Dana 300 in my CJ7 and have a 4" BDS lift. I still had clearance issues with the driveshaft so I built a pillow block support and ordered a two piece front driveshaft. This thing shakes like a homedepot paint mixer. I know people have done this before but I havent found detailed enough info on how to execute without creating a vibration. I dont want to blow apart my U-Joints after one of two times on the trail. Any tips?
I have a TF727/Dana 300 in my CJ7 and have a 4" BDS lift. I still had clearance issues with the driveshaft so I built a pillow block support and ordered a two piece front driveshaft. This thing shakes like a homedepot paint mixer. I know people have done this before but I havent found detailed enough info on how to execute without creating a vibration. I dont want to blow apart my U-Joints after one of two times on the trail. Any tips?