Warn Hubs, pay attention to this forum

[73CJ]

Hard use and big tires don't like hub bolts period.

I tried LocTite, studs finally dumped the hubs and went F150 internal hubs. End of problem.

 

[diddy2003]

The bolts loosening is pretty common, especially on a 5 bolt. My buddy has to tighten his pretty much every time we go wheeling. I just switched from MM hubs to warn premium 6 bolts. I went with the studs and nuts. Much better system. No worrying about them loosening up.
Before:


After:

 

[Lumpy Grits]

Threaded studs and ny-lock nuts torqued to 35 ft/lb has kept my Mile Marker hubs in place with no loosening at all, for years.
I have a D/L in the front and run 33" tires.
The issue is the junk zinc metal used by Warn.
MM uses steel.
LG

 

[Lumpy Grits]

The bolts loosening is pretty common, especially on a 5 bolt. My buddy has to tighten his pretty much every time we go wheeling. I just switched from MM hubs to warn premium 6 bolts. I went with the studs and nuts. Much better system. No worrying about them loosening up.
Before:


After:

Look'n at the washers in your last picture-Are you sure you can remove the wheel??
Use AN washers........
LG

 

[mtnwhlr]

Look'n at the washers in your last picture-Are you sure you can remove the wheel??
Use AN washers........
LG

I'm looking at the pic and can see they are inside of the outer lip of the hub so I don't see how they could be a problem.

 

[Lumpy Grits]

The washers protrude outboard of the hub's base flange.
The wheel's center section may very well not clear....
LG