Misc. Warn Lockout Hub Inner Bearing
- Posts
- 418
- Featured
- 3
- Media
- 135
- Resources
- 2
- Solutions
- 1
- Thanks
- 220
- Location
- Colorado
- Vehicle(s)
- 1986 CJ7 Laredo:
258 w/Howell TBI, HEI Ign., Dana 44 Front w/Detroit, Dana 44 Rear w/Discs & Detroit,
NP435 Trans, Dana 300 T-case w/twin stick
1969 Bronco:
351W, D44 high pinon front from full size, 9” full size rear, NP435 trans and Dana 20
Replacing the front brake rotors and discovered a loose needle bearing inside the hub assembly. I believe it came from the inner bearing, at the very back of the Warn hub body.
Did some searching on the internet and this site and didn't come up with a replacement for the bearing. Any ideas out there?
I think the bearing is a "Torrington Y-246" . But, I can't seem to find that part.
Thanks.
Did some searching on the internet and this site and didn't come up with a replacement for the bearing. Any ideas out there?
I think the bearing is a "Torrington Y-246" . But, I can't seem to find that part.
Thanks.

Last edited: