What did you do to or with your CJ today?
- Posts
- 12,365
- Featured
- 3
- Media
- 71
- Resources
- 2
- Thanks
- 278
- Location
- Rockwall,TX
- Vehicle(s)
- 1983 cj7, 1971 Dart, 1942 Willys slat grill
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
What did you do to or with your CJ today?
- Thread starter fishinfool98
- Start date Start date:
- Last post Last post:
Belizean
Always Off-Roading Jeeper
- Posts
- 6,955
- Featured
- 1
- Media
- 20
- Solutions
- 3
- Thanks
- 727
- Location
- New Orleans area
- Vehicle(s)
- 84 CJ7 4 banger-owned since new in 1984 bought off truck at dealership - rebuilding 258, T176 with Sniper EFI D300 4:1 Lomax gears Twin Sticked 1 piece axels with locker
They will only miss it with 33 degrees rain with the top off
Posi
Always Off-Roading Jeeper
- Posts
- 8,043
- Media
- 172
- Thanks
- 82
- Location
- New England
- Vehicle(s)
- 54 Willys 3B, FI 401, T-18, ARB Locked, Hinkey Sidewinder Winch
It was a fantastic week, back in Colorado Springs.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Posts
- 348
- Thanks
- 8
- Location
- Mt. Cheaha, AL
- Vehicle(s)
- '84 CJ7, 258, T4, D300, D30, AMC20, 3.54 gears
NP435
Jeeper
- Posts
- 242
- Solutions
- 1
- Thanks
- 95
- Location
- Wyoming Usa
- Vehicle(s)
- CJ7 Reman 258, Np435, twin stick 300 dana, Currie 44's both ends with DetroitTrac both ends and chrome moly 35 spline shafts, Maxis Razor 33;s Gps based speedo.
I hope to be in Moab May 2023, this time with no jeep carnage.It was a fantastic week, back in Colorado Springs.
Sent from my iPhone using Tapatalk
Posi
Always Off-Roading Jeeper
- Posts
- 8,043
- Media
- 172
- Thanks
- 82
- Location
- New England
- Vehicle(s)
- 54 Willys 3B, FI 401, T-18, ARB Locked, Hinkey Sidewinder Winch
NP435, We will just miss you. Our run is planned for April 16th 23.
Gert, I have a spot open for you!
Sent from my iPhone using Tapatalk
Gert, I have a spot open for you!
Sent from my iPhone using Tapatalk
- Posts
- 2,354
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 719
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
Bucket listNP435, We will just miss you. Our run is planned for April 16th 23.
Gert, I have a spot open for you!
Sent from my iPhone using Tapatalk
Sent from my E7110 using Tapatalk
Belizean
Always Off-Roading Jeeper
- Posts
- 6,955
- Featured
- 1
- Media
- 20
- Solutions
- 3
- Thanks
- 727
- Location
- New Orleans area
- Vehicle(s)
- 84 CJ7 4 banger-owned since new in 1984 bought off truck at dealership - rebuilding 258, T176 with Sniper EFI D300 4:1 Lomax gears Twin Sticked 1 piece axels with locker
Nice pictures Posi
- Posts
- 12,365
- Featured
- 3
- Media
- 71
- Resources
- 2
- Thanks
- 278
- Location
- Rockwall,TX
- Vehicle(s)
- 1983 cj7, 1971 Dart, 1942 Willys slat grill
NP435, We will just miss you. Our run is planned for April 16th 23.
Gert, I have a spot open for you!
Sent from my iPhone using Tapatalk
Sweet, im not a 100% sure im going yet
Sent from my iPhone using Tapatalk
- Posts
- 2,354
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 719
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
Rewired for the win. Even found duck tape splices
Sent from my E7110 using Tapatalk
Sent from my E7110 using Tapatalk
TSB8C
Old Time Jeeper
- Posts
- 1,196
- Featured
- 13
- Media
- 26
- Resources
- 1
- Solutions
- 30
- Thanks
- 664
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
What's in the tupperware?
- Posts
- 2,354
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 719
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
Everyone asks that. That's where I ran all my breather hoses. Sealed it with rtv drilled holes in the top for air and small ones in the bottom for drainage. All was done after the event in my avatar
Sent from my E7110 using Tapatalk
Patrick
Old Time Jeeper
- Posts
- 1,033
- Solutions
- 1
- Thanks
- 189
- Location
- El Paso, TX
- Vehicle(s)
- 82 CJ5, LS 6.2, NV3550/D300, D44/30
68 CJ5, 350, Muncie/D18, D44/27 under construction
TSB8C, I’d like to see your engine bay, would you post a pic sir…
TSB8C
Old Time Jeeper
- Posts
- 1,196
- Featured
- 13
- Media
- 26
- Resources
- 1
- Solutions
- 30
- Thanks
- 664
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
Patrick
Old Time Jeeper
- Posts
- 1,033
- Solutions
- 1
- Thanks
- 189
- Location
- El Paso, TX
- Vehicle(s)
- 82 CJ5, LS 6.2, NV3550/D300, D44/30
68 CJ5, 350, Muncie/D18, D44/27 under construction
Ha! Nice! I see that you avoided exhaust headers. I wish I could have done the same and reused the heat shielded stock exhaust manifolds on my rig. Thanks for posting. I will post mine when I get off work tonight.
Patrick
Old Time Jeeper
- Posts
- 1,033
- Solutions
- 1
- Thanks
- 189
- Location
- El Paso, TX
- Vehicle(s)
- 82 CJ5, LS 6.2, NV3550/D300, D44/30
68 CJ5, 350, Muncie/D18, D44/27 under construction
And if you are in the very high ampere capacity club, modern LT GM engines have alternators with crazy power output and can be adapted. FYI
TSB8C
Old Time Jeeper
- Posts
- 1,196
- Featured
- 13
- Media
- 26
- Resources
- 1
- Solutions
- 30
- Thanks
- 664
- Location
- Cut-n-Shoot, TX
- Vehicle(s)
- 1984 CJ7, 420 HP "ZZ6 EFI" Crate engine, 700R4, D300, Dana30 front, Dana489 rear, 4.56 gears, 4" lift
Yes. I have a 105 amp alternator on my Crate ZZ6 engine. I bought the "turnkey" version with the serpentine belt accessory drive kit. That came with the AC compressor, alternator, power steering pump, long nose water pump, and all the pulleys and the idler.
Patrick
Old Time Jeeper
- Posts
- 1,033
- Solutions
- 1
- Thanks
- 189
- Location
- El Paso, TX
- Vehicle(s)
- 82 CJ5, LS 6.2, NV3550/D300, D44/30
68 CJ5, 350, Muncie/D18, D44/27 under construction
Well, here it is.
Patrick
Old Time Jeeper
- Posts
- 1,033
- Solutions
- 1
- Thanks
- 189
- Location
- El Paso, TX
- Vehicle(s)
- 82 CJ5, LS 6.2, NV3550/D300, D44/30
68 CJ5, 350, Muncie/D18, D44/27 under construction
Let’s see some more, don’t be shy and show your engine bay!
- Posts
- 2,354
- Featured
- 1
- Media
- 188
- Solutions
- 11
- Thanks
- 719
- Location
- Thurmont MD
- Vehicle(s)
- 85 CJ7 4.2L 258 .040 over, T-5 trans, dana 300, dana 30 front 3.23 and lock right locker, rear amc 20 3.23 one piece axle shafts traclock
79 CJ7 304, th400 auto borgwarner 1389?? qudratrac stock rest unknown.
89 YJ 4.2L 258, AX-15 5spd, NP231, dana 30 front, dana 35 rear with posi, gears unknown
92 YJ 4.0, AX-15 5spd, np231, dana 30 front, dana 35 rear.
Similar threads
-
Question
Reply's are voted
on for best answer
- Solved