• Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.

Engine 151 Iron Duke 151 CI O-Ring location

Engine 151 Iron Duke 151 CI O-Ring location

CJ51980

Jeeper
Posts
3
Thanks
0
Location
Tuscumbia, AL, USA
Vehicle(s)
1980 Jeep CJ5 151 2.5L Iron Duke
I'm in the process of building a 1980 GM 151 CI Iron Duke and the Felpro Gasket kit has a rubber o-ring that has a square cut cross section. I can't find where it it should be installed. It fits perfectly in the Crank hub/Balancer that's behind the crank pulley, underneath the crank bolt. I don't think that's where it goes but not sure.

Thanks for the advice
 
You don’t think it’s for your thermostat housing…

The gasket kit might include a description of its contents.
 
You don’t think it’s for your thermostat housing…

The gasket kit might include a description of its contents.
Could be, I was gonna check that but haven't gotten to installing the t-housing yet. Sounds like a good idea, thanks.
It did include a description but It wasn't very thorough.
Thanks again, I'll let you know if that was it..👍
 

Jeep-CJ Donation Drive

Help support Jeep-CJ.com by making a contribution.

Help support Jeep-CJ.com by making a contribution.
Goal
$200.00
Earned
$0.00
This donation drive ends in
0 hours, 0 minutes, 0 seconds
  0.0%
Back
Top Bottom