What did you do to or with your CJ today?

[jamie]

had to move mine to the back of the garage next to my 68 bronco. needed to make enough room to put my f150, expedition and matrix inside to avoid the impending doom of irene. some hurricane, we didnt even lose power. had to put all the lawn furniture in as well. looks like a tornado in my garage

 

[BusaDave9]

I replaced the electrical ignition switch in my CJ

 

[jdenney]

drove it to my new house and made sure it would clear under my 7 ft garage door and it does by a quarter of an inch!!!

 

[JR74CJ5]

drove it to my new house and made sure it would clear under my 7 ft garage door and it does by a quarter of an inch!!!

 

[1986cj7]

Set timing to 12 degrees btdc at 1600rpm like sticker at rad says runs like a champ now. Just a question, where to find this info if sticker is not there. The chilton says 9 but doesn't say what rpm. Others say 9.5 and still others say 8 but don't say what rpm. I even checked the timing after setting to 12 and it was 6 at an idle. Now after tinckering with the timings I also had to adjust the carb a little, because I had been tinckering with it before setting the timing back to 12.

 

[SKT]

.

Nice looking CJ there SKT.

Do you take that Jeep back in the muddy, tight trails?

It appears to be too nice to scratch.

SKT CJ7 Looks Great Just not an offroad jeep!

Thanks for the compliments on the '7!

No hard wheeling for this one, just some occasional DD duties and mild trail rides...



.

 

[LongHorn]

drove it to my new house and made sure it would clear under my 7 ft garage door and it does by a quarter of an inch!!!:d

 

[zuba]

I x2 that

 

[Old Dog]

Got the cj ready for the big Harlan Ky. labor day weekend ride.
Toped off all the fluids.
Got the tool box, recovery gear, and air tank loaded and straped down.
Oh yea I washed it inside and out just so it can look good on the way down.
Tomorrow after work it's the trucks turn, we're leaving friday morning so
thursday night will be for loading everything up to leave early.

 

[zuba]

Sounds great week end , have fun

 

[Pickle]

Took the original spare off the rim for the new set of grip

 

[OldC7]

Put on new front exhaust pipe today. Ordering muffler and tailpipe now.

 

[BusaDave9]

Got the cj ready for the big Harlan Ky. labor day weekend ride.
Toped off all the fluids.
Got the tool box, recovery gear, and air tank loaded and straped down.
Oh yea I washed it inside and out just so it can look good on the way down.
Tomorrow after work it's the trucks turn, we're leaving friday morning so
thursday night will be for loading everything up to leave early.

Sounds like fun. You'll have to do a trail report or at least post some pictures. I'd like to see what that place is like and I'm sure there are others that are interested.

 

[Muddog]

installed the rear suspension on my CJ3a project... front suspension is next

 

[OldC7]

New gas tank and sending unit installed today and dropped the skid plate and put new torque arm bushings on.
Hopefully tomorrow new fuel line ran and start welding in another body mount repair.

 

[1986cj7]

Pulled rad had a leak 5 inches from the top on drivers side. Getting tired of taking this rad out!!! This time though I just JB welded the pin hole up. I've got $160 in cleaning out this rad. Should have just bought a new one for $285 I'm already half way there. If one more leak and this one will go and a new one will be on the way! All well, all in a day in jeeping and repairing!

 

[jonboy1919]

I went 4x4ing again with my stepson in the Cascade Mts. above Darrington, WA. Once again, I had a blast and am so glad I purchased this wonderful, firecracker red money sucker! I LOVE IT!!!

 

[CJ007]

Painted my hubs red to match my other Cards red stuff.









Yea, I like the Cards!

 

[dirtdobber]

donated some more knuckle flesh - (I have to get me some work gloves)
I installed a tuffy console.

 

[zuba]

Time to change oil and air filters.:drool: