You Just Might Be......
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
You Just Might Be......
- Thread starter project74
- Start date Start date:
- Last post Last post:
73CJ
Crazy Sr. Respected Jeeper
- Posts
- 3,533
- Media
- 57
- Thanks
- 10
- Location
- Detroit Lakes, MN
- Vehicle(s)
- 73 CJ5 4.0 head on a 258, HEI, Holley Projection w/ 4.56, Detroit lockers Narrowed D44 front and full float D44 rear T14 w/ D20 4 wheel discs, 38.5 Boggers
jasonmark1993
Old Time Jeeper
- Posts
- 1,366
- Media
- 10
- Thanks
- 3
- Location
- El Paso TX
- Vehicle(s)
- FJ cruiser (wifes ride)
2008 ZX10R,
73 CJ5, 408W, Toploader, Dana 20, 9" Dana 30 5.38 gears, next purchase=slicks
Not sure if this is your first one, but check the center pin diameter.
I was a rookie at this and thought that maybe my new pin was just a little tighter. Wrong.
F you Crown and 4 wheel parts.
Got a new kit from Novak and it slid right in by hand like it should. Just had to tap it into the back part of the case.
Let me know if you are able to pull the bearings off the front wheel drive shaft. I tried everything and finally cut through the inner race with a torch.
I was a rookie at this and thought that maybe my new pin was just a little tighter. Wrong.
F you Crown and 4 wheel parts.
Got a new kit from Novak and it slid right in by hand like it should. Just had to tap it into the back part of the case.
Let me know if you are able to pull the bearings off the front wheel drive shaft. I tried everything and finally cut through the inner race with a torch.
Similar threads
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer