Drive shaft lube
yellow85cj
Senior Jeeper
- Posts
- 672
- Media
- 3
- Resources
- 1
- Solutions
- 3
- Thanks
- 32
- Location
- Ft Worth,TX
- Vehicle(s)
- 85 CJ7, 258,4.0 head, T177, D300, Dana 30, AMC 20, 3.54
What lube is everyone using to lube their drive shafts ?
-
Hello Guest, we are proud to now have our Wiki online that is completely compiled and written by our members. Feel free to browse our Jeep-CJ Wiki or click on any orange keyword when looking at posts in the forum.
Drive shaft lube
- Thread starter yellow85cj
- Start date Start date:
- Last post Last post:
- Posts
- 14,791
- Thanks
- 55
- Location
- Springfield, Missouri-U.S.A. Earth
- Vehicle(s)
- '85 CJ-7, 258/4.2L 6cyl. Bought new in 1985. Full cage, Warn 8274 winch, Ford 9" rear, front/rear Detroit Lockers w/4:88 R&P. T-5 tranny and 4:1 t'case. 33X12.50-15 BFG/AT, MSD ign, on board air---
I would clean the rust off with some scotchbright.
Same grease you used to lube the ball-joints etc.
LG
Same grease you used to lube the ball-joints etc.
LG
Torxhead
Always Off-Roading Jeeper
On the short end of the driveshaft there could be a small hole, if so you can put your finger over that hole as you fill it with grease. This will allow you to really fill up that seal.
Similar threads
- Solved
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
-
Question
Reply's are voted
on for best answer
